RotaryEngineIllustrated.com Forum Index RotaryEngineIllustrated.com
This site endeavors to be the best resource on the internet for educational material on the Rotary Engine.
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

why is one 20b intermediate plate wider then the other?

 
Post new topic   Reply to topic    RotaryEngineIllustrated.com Forum Index -> The Round Table
View previous topic :: View next topic  
Author Message
EVLRX-4



Joined: 28 Oct 2005
Posts: 17
Location: Australia, Melbourne

PostPosted: Tue Nov 29, 2005 6:21 pm    Post subject: why is one 20b intermediate plate wider then the other? Reply with quote

hey i was just wondering why is one 20b intermediate plate wider then the other?
_________________
Back to top
View user's profile Send private message MSN Messenger
EVLRX-4



Joined: 28 Oct 2005
Posts: 17
Location: Australia, Melbourne

PostPosted: Tue Nov 29, 2005 7:41 pm    Post subject: Reply with quote

Ok i think i have figured it out.
Is it because there is two lots of through bolts short and long ones?
So do they bolt from each end of the engine?
but a 13b bolts only from the rear is that correct?
_________________
Back to top
View user's profile Send private message MSN Messenger
Jingyee
Site Admin


Joined: 11 Jul 2005
Posts: 85
Location: Portland, OR

PostPosted: Wed Nov 30, 2005 2:20 am    Post subject: Reply with quote

Well for one, the plate must hold an additional stationary gear, which makes it wider. And yes, there are short and long bolts, that do bolt from each end of the engine. Some bolt into that large plate, and others go all the way across.

You are correct, 13b are only bolted through the rear plate.
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address MSN Messenger
Display posts from previous:   
Post new topic   Reply to topic    RotaryEngineIllustrated.com Forum Index -> The Round Table All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group